R**D
Not as pictured
Not quite as pictured; because the switch had a screw instead of a stud with a nut it was difficult to install in a tight space. Switch functioned well.
D**E
replces OEM part OK
Seceond time in 15 yrs my generator stopped running due to bad pressure switch. Not a perfect match, but replaced OEM part OK
S**.
Fixed my generators problem
My generator would stall/quit right after starting up. My old oil pressure switch/sensor was bad. This has corrected the problem. Was easy to install.
J**Y
Easy to install.
Replacing my defective oil pressure sensor brought my General generator back to life. If your generator dies after a few seconds, then disconnect the wires to verify your old one is defective.
S**H
Wire connector different than original but still works.
The item worked as expected. It was a bit difficult to install since it has a screw that you cannot get to once installed.
L**E
Not the same as pictured
This oil sensor is misrepresented in the photo. It was difficult to install as it is not an exact fit. It fits but just barely. I have attached a photo of the old one and the purchased one side by side. The photo they provide shows a stud with nuts and thread locker; it doesnt have either of those things. Has chinese writing and the year 2017 on it which makes the part I recieved 3 years old. There is another review that says pretty much the same thing; believe it
G**N
Oil Pressure Switch
work out OK
B**E
Quick shipping
Used to replace faulty switch on my generator. A quick swap out and generator was up and running.
Trustpilot
3 weeks ago
2 weeks ago
