Tecmolog Shower On Off Valve Brass 3 Way Shower Valve G 1/2 Diverter Valve for Hand Shower, Black Shower Parts, DSF007C

Easy to fit, looks good and smooth easy operation.

It was very easy to install, came with PTFE tape and spare plastic thingies (don't know how they are called). I am really happy with it. I live on rental so can't do permanent improvements so with this I attached the old shower head and my new hand set and works like a charm and can remove any time! It's sturdy, doesn't leak and water pressure stayed the same.

The media could not be loaded.  I needed to control the flow of water to a bidet as it was too punishing, this seemed like a respectable choice and a nice upgrade from the included stock part. The finish accurately reflected the online photographic imagery and it had a sturdy construction, with a sturdy swivel action.In use I can confirm that the part will operate the flow of water to both exists at maximum until the 3pm position (half way), from then on the water is cut off and only supplied to one exit valve, which gradually increases the flow until the 6pm position (maximum).Installation for a novice such as myself was no trouble, the only issue being the valve which infinitely rotates, rather than having the traditional hexagonal nut shape to it, which meant that it had to be hand tightened. Although the internal rubber seal should have prevented the water from leaking, I found that it needed PTFE tape as well as I couldn’t use a tool as with the opposite end.

Worked perfectly, easy to fit.

The look and feel of this device is of a high standard. It came with either two or three washers (I may have got parts muddled) and a small roll of PTFE tape. I found that the flow rate was significantly reduced through this diverter, as can be understood by seeing that the water has to pass through a small hole inside of the 1/2 inch connector (see photos). The straight through connector had a hole with diameter of about 5mm and the right angled one was about 6mm in diameter.Your experience with pressure and flow rate will vary as it depends on the overall impedance of your plumbing and the initial water pressure. I performed a simple measurement though on my shower using the straight through (smaller of the holes) connector with my shower head. I compared it to a competing product which I also bought (https://www.amazon.co.uk/dp/B0BCFNL4S4). It took 24 seconds to fill a container (approx 1l) using the present product and only 17 seconds using the alternative product (which is basically a T piece with a separate valve on two ends). I didn't compare to having no diverter.I think this is a bad design, even though the finish is nice and the valve moves in a nice way.

Absolutely no leaking, super easy to install. Excellent quality

Can now use two separate shower heads

Very useful product. My wife wanted a second hose in shower to wash hair whilst also having overhead shower head on. Works perfect for this giving two outlets instead if the one that was on the shower. Be careful to leave in the centre position (both outlets open). If not then you will get a blast of cold water in shower when you try to switch shower head before the warm water comes through.

Diminution du goulot intérieur donc Diminution de la pression dmg

macht was es soll gutes Produkt

Buen funcionamiento y buenos acabados